01717584708 info@fablabiub.com
Module Li Ion charging Dual USB

Module Li Ion charging Dual USB

Description: This PCB can step-up a lithium ion battery to 5V for dual USB output to 5V USB devices, like iPhone, mobile phone, tablet PC. This module also contains protection circuit which will stop step-up output when Lithium ion battery is below 2.5V....

LDR Sensor

LDR Sensor

Equipment Description: The photoresistor is generally uesd to take photosensitive resistor measurement, light control and photoelectric conversion (light changes into electricity). The resistance light dependent resistor change with the change of the...

Module Boost Converter MOD-00045

Module Boost Converter MOD-00045

Description: This is a breakboard boost converter. Supply volatage as low as 3.7v, it boosts to as high as 34v.  With this module, you can now power your Arduino with our 3.7V lipo battery. Figure: Module Boost Converter Specifications: Input...

Barrometric bmp180

Barrometric bmp180

Equipment Description: This precision sensor from Bosch is the best low-cost sensing solution for measuring barometric pressure and temperature. Because pressure changes with altitude you can also use it as an altimeter! The sensor is soldered onto a PCB...

AtTiny85

AtTiny85

Equipment Description: The high-performance, low-power Microchip 8-bit AVR RISC-based microcontroller combines 8KB ISP flash memory, 512B EEPROM, 512-Byte SRAM, 6 general purpose I/O lines, 32 general purpose working registers, one 8-bit timer/counter with...

Arduino Uno

Arduino Uno

Equipment Description: Arduino Uno is a microcontroller board based on the ATmega328P (datasheet). It has 14 digital input/output pins (of which 6 can be used as PWM outputs), 6 analog inputs, a 16 MHz quartz crystal, a USB connection, a power jack, an...

Electronics

Share This